Endress+Hauser Proline Promag W 400 HART, Operating Instructions Manual

Page: 111 / 198

Proline Promag W 400 HART Commissioning
Hauser 111
Frequency output simulation 1 to n →  112
Frequency value 1 to n →  112
Pulse output simulation 1 to n →  112
Pulse value 1 to n →  112
Switch output simulation 1 to n →  112
Switch status 1 to n →  112
Device alarm simulation →  112
Diagnostic event category →  112
Diagnostic event simulation →  112
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Assign simulation process variable – Select a process variable for
the simulation process that is
activated. • Off
• Mass flow
• Volume flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Temperature
Off
Process variable value One of the following options is
selected in the
Assign
simulation process variable
parameter (→  111):
• Volume flow
• Mass flow
• Corrected volume flow
• Flow velocity
• Conductivity
*
• Corrected conductivity
*
• Temperature
Enter the simulation value for
the selected process variable. Depends on the
process variable
selected 0
Status input simulation For the following order code:
• "Output; input", option I
"4-20mA HART, 2x pul./
freq./switch output; status
input"
• "Output; input", option J
"4-20mA HART, certified
pulse output, switch output;
status input"
Switch simulation of the status
input on and off. • Off
• On Off
Input signal level In the Status input simulation
parameter, the On option is
selected.
Select the signal level for the
simulation of the status input. • High
• Low High
Current output 1 simulation – Switch the simulation of the
current output on and off. • Off
• On Off