Endress+Hauser Micropilot NMR84, Operating Instructions Manual

Page: 136 / 256

Operating menu Micropilot NMR84
136 Hauser
User entry –213 to 927 °C
Factory setting –100 °C
Additional information
Read access Operator
Write access Maintenance
Maximum probe temperature 
Navigation  Setup → Advanced setup → Input/output → Analog IP → Max. probe temp
Prerequisite Operating mode (→  132) = RTD temperature input
Description Maximum approved temperature of the connected probe.
If the temperature rises above this value, the W&M status will be 'invalid'.
User entry –213 to 927 °C
Factory setting 250 °C
Additional information
Read access Operator
Write access Maintenance
Probe position 
Navigation  Setup → Advanced setup → Input/output → Analog IP → Probe position
Prerequisite Operating mode (→  132) = RTD temperature input
Description Position of the temperature probe, measured from zero position (tank bottom or datum
plate). This parameter, in conjunction with the measured level, determines whether the
temperature probe is still covered by the product. If this is no longer the case, the status of
the temperature value will be 'invalid'.
User entry –5 000 to 30 000 mm
Factory setting 5 000 mm
Additional information
Read access Operator
Write access Maintenance