Endress+Hauser Levelflex FMP56, Operating Instructions Manual

Page: 202 / 210

Operating menu Levelflex FMP56, FMP57 FOUNDATION Fieldbus
202 Hauser
Description of parameters
Navigation  Expert → Diagnostics → Simulation
Assign measurement variable 
Navigation  Expert → Diagnostics → Simulation → Assign meas.var.
Description Selct process variable to be simulated.
Selection • Off
• Level
• Interface
*
• Level linearized
• Interface linearized
• Thickness linearized
Factory setting Off
Additional information • The value of the variable to be simulated is defined in the Process variable value
parameter (→  202).
• If Assign measurement variable ≠ Off , a simulation is active. This is indicated by a
diagnotic message of the Function check (C) category.
Process variable value 
Navigation  Expert → Diagnostics → Simulation → Proc. var. value
Prerequisite Assign measurement variable (→  202) ≠ Off
Description Specify value of the process value being simulated.
User entry Signed floating-point number
Factory setting 0
Additional information Downstream measured value processing and the signal output use this simulation value. In
this way, users can verify whether the measuring device has been configured correctly.
Switch output simulation 
Navigation  Expert → Diagnostics → Simulation → Switch sim.
Description Switch the simulation of the switch output on or off.
* Visibility depends on order options or device settings