Dosimass
Safety instructions
Hauser
5
1.4
Return
The measuring device must be returned if repairs or a factory calibration are required, or if wrong
measuring device has been ordered or delivered. According to legal regulations, Hauser,
as an ISO-certified company, is required to follow certain procedures when handling returned
products that are in contact with medium.:
To ensure swift, safe and professional device return, please read the return procedures and
conditions on the Hauser website at www.services.endress.com/return-material.
1.5
Notes on safety conventions and icons
The devices are designed to meet state-of-the-art safety requirements, have been tested, and left the
factory in a condition in which they are safe to operate. The devices comply with the applicable
standards and regulations in accordance with EN 61010 "Protection Measures for Electrical
Equipment for Measurement, Control, Regulation and Laboratory Procedures". They can, however,
be a source of danger if used incorrectly or for use other than that designated.
Consequently, always pay particular attention to the safety instructions indicated in these Operating
Instructions by the following icons:
#
Warning!
"Warning" indicates an action or procedure which, if not performed correctly, can result in injury
or a safety hazard. Comply strictly with the instructions and proceed with care.
"
Caution!
"Caution" indicates an action or procedure which, if not performed correctly, can result in incorrect
operation or destruction of the device. Comply strictly with the instructions.
!
Note!
"Note" indicates an action or procedure which, if not performed correctly, can have an indirect
effect on operation or trigger an unexpected response on the part of the device.
