Power supply
The sampler is delivered with a 3core mains cable (length approx. 1.4m)
connected to a 2 pin plug with earth contact.
This cable is fed through the sampler left side panel and is already
connected to the mains terminals (KL1/1, KL/2 and PE) in the terminal box.
Terminal box
Open the cabinet door.
The terminal box is situated behind the hinged blanking plate (2) at the base
of the sampler.
Remove the mains plug from the power supply (the system must be
without power).
Push both snap locks (1) inwards and hinge the blanking plate (2)
downwards. The terminal box (3) can now be seen.
Undo screws (4) and remove the terminal box lid.
There is a terminal connection diagram stuck to the inside of the lid.
The terminal box contains all in/output terminals, TTY interface for direct
connection to the
Primo-Bit sample protocol printer, internally connected
cables to the functional module, alarm and sample sequence end relay
outputs (for retransmission), heating and cooling relays (internal) as well as
the mains fuse SI1 (6,3AT).
asp-station d 2
Electrical intallation
9
