© 2010-2021 – Endorphin.es®
YOU WILL HAVE NIGHTMARES FOREVER
CABIN PRESSURE SCAN:
by pressing and
holding the
TYPE + TAP
buttons simultane-
ously for longer than 1 second, you enable
the effect type change under incoming CV.
Every effect type has a memory, so the val-
ues of every parameter are stored and then
immediately recalled under incoming CV
for a certain effect type. In that mode, the
CABIN PRESSURE parameter is no longer CV
controlled and works only as a manual DRY/
WET control. The CV input for CABIN PRES-
SURE accepts bi-polar -5...+5V CV signal and
changes the type of effect under incoming
CV. The range of -5...+5V is divided into 8
zones (with adjusted hysteresis range) with
approx. 1.25V per step. If the incoming CV is from -5V to -3.75V, then the first effect type is chosen. If the CV is in the range from
-3.75 to -2.5V, then the second effect is chosen and so on, up to the 8
th
effect.
NOT A NIGHTMARE IF YOU KNOW WHAT YOU ARE DOING
IMPORTANT:
Because the DSP in the module can only handle loading one effect at once, very fast scanning of effects may
cause clicks. There are small crossfades in volume during effect transitions, and we tried to minimize the clicks as much as
possible, but they cannot be fully eliminated.
I’M THE DEATH
In case you tweaked everything so hard, you finally don’t hear any signal from the main outputs, or only things you don’t want
to hear, there is a soft reset that adjusts all parameters to their default values, so you may start tweaking from the beginning.
Reset also clears all effect memories. Press both TYPE and TAP buttons simultaneously and hold for more than 5 seconds. You
may hear a short blip and then you will see the effect will be set to the first cell by one green blink.
This works for Grand Terminal, Blck_Noir and Milky Way: