• Re-fit the tubes and the side panels. NOTE: When fitting
the side panels –please make sure that there is a gap
between the side panels and the door as shown. This
gap is required so that the door does not contact, and
damage, the side panels when it is opened. Make sure
that all rubber washers are used under the fixing screws
– to protect the fitting against water ingress and that no
cables are trapped.
• Position the shelves as required. To loosen the shelves,
turn the knurled nuts CLOCKWISE. Move them to the
desired slots then turn them ANTI-CLOCKWISE to secure.
Turn on the power and test the lights (pull cord) and
shaver socket.
Commissioning
Instruction leaflet
Milos Mirror
EL-MILOS
(56589)
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Endon Lighting LS9 0SE
• We recommend cleaning with a soft dry cloth. Do not use
solvents or abrasive cleaners as these could damage the
finish.
• Mirror – Use a damp cloth or a propriety glass cleaner.
Do not use abrasive materials as these will damage the
finish.
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
• The shaver socket is powered by a 20W isolating
transformer and is only intended for use with electric
shavers, electric toothbrush chargers and similar
products.
• Any appliance connected to the socket must not exceed
the 20W power output as this could cause damage and
overheating to occur.
• Always check your appliance instructions to ensure the
power requirements are less than 20W.
Shaver Socket Instructions
Iss.4 14102016
Replace Cracked Shade
