16
Owners manual: model 5515 outdoor patio heater 06-01-2010
WARNING
FOR YOUR SAFETY
Heater will be hot after use
Handle with extreme care
3.3 LIGHTING
1. Push control knob IN and turn to OFF.
2. Turn the gas tank valve ON.
3. Depress the burner control knob and turn it (anticlockwise) to the igniting position.
4. Press the piezo-ignition concurrently with your other hand and hold the pressed knob
for about 10 seconds after ignition in order to activate the ignition safety switch. Should
the gas fail to ignite after pressing the piezo-ignition 3 or 4 times, leave the appliance
for about 5 minutes that any gas to clear and then repeat the process.
Note:
It is possible to ignite the burner using other ignition devices
(gas lighters, matches) through the 0.73 inch aperture in the bottom of the burner.
Caution:
Avoid inhaling fumes emitted from the heater‘s first use. Smoke and odour from the
burning of oils used in manufacturing will appear. Both smoke and odor will dissipate
after approximately 30 minutes. The heater should NOT produce thick black smoke.
Note:
The burner may be noisy when initially turned on. To eliminate excessive noise from the
burner, turn the Control Knob to the small flame position. Then, turn the knob to the
level of heat desired.
3.4 WHEN HEATER IS ”ON”
Emitter screen will become bright red due to intense heat. The colour is more visible at
night. Burner will display tongues of blue and yellow flame. These flames should not be
yellow or produce thick black smoke, indicating an obstruction of airflow through the
burners. The flame should be blue with straight yellow tops.
3.5 RE-LIGHTING
Turn Control Knob to 0FF
Wait at least 5 minutes, to let gas dissipate, before attempting to relight.
Repeat the “Lighting“ steps on prior page.
3.6 SHUTDOWN
1. Turn the burner control knob clockwise to the igniting position.
2. Depress the control knob and turn it clockwise to OFF.
3. Turn tank valve clockwise to OFF. Disconnect the regulator when heater is not in use.
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the
type of dust cap on the cylinder valve outlet that is provided by the cylinder valve. Other
types of caps or plugs may result in leakage of propane.
WARNING
FOR YOUR SAFETY
Be careful when
attempting to manually
ignite this heater.
Holding in the control
knob for more than 5
seconds before igniting
the gas will cause a ball
of flame upon ignition.
5515_USA_RATTAN_060110.indd 16
07.01.10 10:27
