15
Owners manual: model 5515 outdoor patio heater 06-01-2010
16 mm
19mm
X
X
X
X
X
LEAK CHECKING GAS LINE AND CYLINDER CONNECTIONS
Step 1: Turn cylinder valve on by turning anti-clockwise.
Step 2: Check connections and valve for leaks. To check for leaks
spoon several drops of solution onto the connections as illustrated.
Step 3: Inspect the solution for bubbles,
if no bubbles appear then the connection is secure.
If bubbles appear, then there is a leak:
Turn OFF the cylinder valve.
Release the regulator connection to the cylinder.
Reattach the regulator, making sure that the connection is tight.
Repeat the leak checking procedure described above.
If you still see bubbles after several attempts
DO NOT USE THE HEATER.
Contact service for assistance.
- Your heater was designed and approved for
Outdoor use only. Do NOT use it inside an enclosure.
- Make sure that all combustibles are maintained
and that there are no flammable liquids or vapors
in the vicinity of the heater.
- Make sure there is no obstruction to air ventilation.
- Be sure that all gas connections are tight and there are no leaks.
- Any components removed during the assembly or servicing
of the heater must be reinstalled.
3.2 BEFORE LIGHTING
- The heater components should be thoroughly inspected before each use and
at least every two years by a qualified service person.
- Inspect the visible portion of the hose before each use of the appliance.
Portions that are located within the heater post, inspect the entire hose assembly at least annually.
- The hose assembly must be replaced prior to the appliance being put into operaton if there is evidence
of excessive abrasion or wear, or if the hose is damaged. The replacement hose assembly shall be that
specified by the manufacturer.
LEAK
CHECKING
see page 14
!
5515_USA_RATTAN_060110.indd 15
07.01.10 10:27
