70
No extruding?
Here is our suggestion for you problem:
1. Check whether the extrusion gear above the motor is loose, and tighten the top wire.
2. Check whether the consumables are knotted or stuck, and straighten them out.
3. Please check whether the nozzle is blocked, need to clean the throat
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
Common product failures
71
How to solve the problem of glue
leakage from the nozzle?
Here is our suggestion for you problem:
1. Please heat the nozzle to 230. in the case of maintaining the temperature, under the
removal of the nozzle kit.
Then remove the heating block and throat separately, after the removal of the nozzle can
be cooled.
2. Prepare a bottle of red glue (online store or hardware store can be purchased).
Apply the red glue to the threads of the throat and let it sit for 1 minute.
Then re-install the throat and heating block, and put the nozzle kit back in place.
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
72
The printing process stopped
automatically?
Here is our suggestion for you problem:
1. Model file problem - Slicing was unsuccessful or not fully exported.
Please re-slice or wait for the export progress buffer to finish.
2. File transfer interrupted during SD card printing - Please replace the SD card or
format the SD card
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
73
What about the fan does not rotate or
there is noise?
Here is our suggestion for you problem:
1. Please clean the fan and check if there is any debris interference
2. Please check whether the screws and fan cover are loose
3. Please check whether the fan blade is damaged or broken
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us