55
How to set the wall thickness?
Here is our suggestion for you problem:
Set the nozzle multiplier as a reference
For example: 0.4 nozzle, set 0.8 / 1.2 is appropriate
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
56
What is the print temperature setting
for PLA consumables?
Here is our suggestion for you problem:
Nozzle temperature 200-210
Hot bed temperature 45-55
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
57
What should I do if the nozzle always
scrapes down the model after it is
printed high?
Here is our suggestion for you problem:
Please turn on the Z-axis lifting height function when pumping back, and set the lifting
height to 0.2mm.
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
58
Why is there always a gap in the
capped part of the model?
Here is our suggestion for you problem:
1. Please thicken the top solid layer, generally 1.2mm can be
2. Please increase the filling rate of the model, generally 20-30% can be
3. Adjust the filling overlap, generally 15-25% can be
4. Modeling problems, please try to repair the model or replace the model
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us
59
Is there always pulling or drooping
material during printing?
Here is our suggestion for you problem:
1. Adjust the drawback speed and drawback length, speed 50-80mm/s, length 6-8mm.
2. Refer to the appropriate printing temperature range of the filament, not too high.
We hope this helps you.
If you need further assistance with this issue, please feel free to contact us