(2) Static IP Address
Select this option to set static IP information. You will need to enter in the encapsulation
type (1483 Bridged IP LLC, 1483 Bridged IP VC-Mux, 1483 Routed IP LLC (IPoA), 1483 Routed
IP VC-Mux), IP address, subnet mask, and gateway address provided to you by your ISP. Each
IP address entered in the fields must be in the appropriate IP form, which is 4 IP octets separated
by a dot (x.x.x.x). The Router will not accept the IP address if it is not in this format.
The following table describes the labels in this screen.
LABEL DESCRIPTION
Encapsulation
Select your encapsulation type from the dropdown list.
Static IP Address
Enter the static IP Address here.
IP Subnet Mask
Enter the IP Subnet Mask here.
Gateway
Enter the Gateway address here.
NAT
Select whether NAT is Enabled or Disabled.
Default Route
Select whether this PVC will be the default route for Internet data.
Dynamic Route
Select the RIP type and direction from the dropdown lists.
Multicast
Select the multicast protocol you wish to use from the dropdown list.
(3) PPPoA / PPPoE
40
Select this option if your ISP requires you to use a PPPoE connection. This option is
typically used for DSL service. Select Dynamic PPPoE to obtain an IP address automatically for
your PPPoE connection. Selection Static PPPoE to use static IP address for your PPPoE
connection. Please enter the information accordingly.
Summary of Contents for ENDSL-A2+WIG2
Page 67: ...66...
