Encore 34K350Z, Operator'S Manual

Page: 14 / 20

ENCORE
D-5
Bypass Valve
In some applications, it is desirable to move the
machine for short distances at low speeds without
operating the engine. Using (A) push the lever forward
and then turn the knob (B) clockwise to lock lever in
forward position. You will need to return the lever to its
previous position prior to operating again.
B
A
Figure 10
Important Note:
Cup side of spring washer
goes against blade.
Spring
Washer
Blade
Blade
Bolt
Figure 9

CAUTION:
TURN OFF ENGINE AND REMOVE KEY BEFORE
MAKING ANY ADJUSTMENTS.
Mower Blades
Check sharpness of mower blades after every 10 hours
of operation. To sharpen blades proceed as follows:
Block front end of mower up or run front up on
ramps.
Remove blade by turning bolt counter clockwise.
Blades should be discarded when worn excessively.
See Sketch.



Sharpen blade with a hand file, electric grinder or
blade sharpener. Wear gloves and eye protection
when sharpening. Grind blade at original bevel.
Check balance of blade by positioning the blade on
a nail or blade balance pedestal. Grind the blade
on the end that is heavier until both sides balance.
Do not wear loose
fitting clothing
which could get
caught in moving
parts. Always
be sure to wear
adequate protective
clothing. Wearing
safety glasses and safety shoes is advisable.
Reinstall blades. Refer to Figure 9 for further
information




.EW"LADE
25 Degrees When Notch Starts
Discard Blade
Dangerous!