Page 8
EN-1000™ Quick Configuration Guide
Returning to the Default Configuration
Caution:
If your EN-1000’s configuration is not correct, try to reconfigure the EN-1000
before returning to the default configuration. Do not perform the action described here
unless there is no other way to resolve problems with the EN-1000 configuration.
1
Power up the unit and wait for 2.5 minutes.
2
On the front of the chassis, insert the end of a paper clip into the hole marked
Reset
.
Note:
The paper clip will stop when it reaches the
Reset
button.
3
Press the paper clip in slightly and hold the button in, while watching the
Sys Status
LED (also on the front of the chassis).
Note:
As you hold the
Reset
button in, the
Sys Status
LED will flash slowly one
time, then again a second time, then (possibly) a third time. Then it will flash fast.
4
When the
Sys Status
LED starts to flash fast, release the
Reset
button.
❖
At this point, the
Cell
LED and
Net Status
LED should flash at the same time.
This indicates that the unit is resetting back to factory defaults.
5
Wait one (1) full minute; then log into the EN™ router’s management system (the GUI
menu) via a web browser.
6
When the Status Overview screen is displayed, select the
Quickstart
tab (returning
on page 2) and proceed again with the EN-1000’s quick configuration.
!
Encore Networks, Inc.
3800 Concorde Parkway, Suite 1500, Chantilly, Virginia 20151 U.S.A.
703-318-7750
