background image

Doc. No.: 01999908 

Revision: B 

5 of 5 

Issue Date: 08/15/21 

WARRANTY STATEMENT 

ENCON  HEREBY  DISCLAIMS  ALL  WARRANTIES  EXPRESSED  OR  IMPLIED  INCLUDING  BUT  NOT  LIMITED  TO 
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT OF THIRD-
PARTY RIGHTS, EXCEPT AS HEREINAFTER PROVIDED. 

Encon Safety Products warrants that for one year from the date of purchase of any Encon products, the product will be free of 
defects in materials and workmanship if properly used and cared for or cleaned under normal conditions in accordance with 
Encon’s use and care instructions and properly installed, if applicable, in accordance with Encon’s installation instructions. With 
respect to the product, Encon’s only obligation and purchaser’s exclusive remedy under this warranty is to repair or replace such 
product; provided that: 

1.  Encon is notified of the defect within one year of shipment, and 
2.  the product is determined by Encon to be defective. 

Encon requires proof of original ownership as proof of warranty coverage, and Encon must receive any claim under this Limited 
Warranty within one year of purchase of the product. 

NOTWITHSTANDING ANYTHING TO THE CONTRARY CONTAINED HEREIN, ENCON SHALL NOT BE LIABLE FOR LOSS, 
DAMAGE, OR EXPENSE ARISING DIRECTLY OR INDIRECTLY AS A CONSEQUENCE OF USE OF THE EQUIPMENT WITH 
OTHER  PRODUCTS  OR  FROM  ANY  OTHER  CAUSE,  INCLUDING  ANY  CONSEQUENTIAL,  INCIDENTAL,  SPECIAL  OR 
EXEMPLARY DAMAGES, EXCEPT FOR ENCON’S OBLIGATION TO REPAIR OR REPLACE DEFECTIVE PRODUCTS AS 
EXPRESSLY PROVIDED IN THIS STATEMENT. 

Replacement parts purchased from Encon are warranted for one year following the shipment of such replacement part, or until 
the expiration of the warranty period for the product, whichever is less. No warranty is given in connection with products that are 
altered without Encon’s expressed written consent. The same warranty limitations and the obligations of Encon as set out herein 
above shall apply to replacement parts. 

Encon’s total liability arising out of this warranty (including, but not limited to, warranty claims) regardless of forum and regardless 
of whether such action or claim is based on tort, contract or otherwise will not exceed the total purchase price of the product. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

6825 W. Sam Houston Pkwy. N 

Houston, TX 77041 

1-800-AT-ENCON / 1-800-283-6266 

[email protected]

 

http://www.enconsafety.com 

 

Summary of Contents for 01060015






Reviews: