USER MANUAL
ENCOM PULSE Link
© 2012-2015 Encom Wireless Data Solutions Inc.
For ENCOM PULSE Link Version 2.2.6
Page 88
IP address. Network performance can suffer greatly if two or more radios
are assigned the same IP address.
IP address
Enter the IP address of the radio. This is an Internet Protocol version 4
(IPv4) address, specified in dotted notation, as shown in the following
example:
Network mask
Enter the network mask. This is an Internet Protocol version 4 (IPv4)
address, specified in dotted notation, as shown in the following example:
Gateway address
Enter the IP address of the radio or router that allows the radio to connect
with devices that are outside of their local LAN or VLAN. This is an Internet
Protocol version 4 (IPv4) address, specified in dotted notation, as shown
in the following example:
Note that the default gateway's IP address must be in the same subnet as
the radio's IP address.
Serial Port Mode
Field Name
Description
Serial Mode
This option sets the protocol used by the iPULSE radio to communicate
with other devices (computer, iPULSE radio, TS1 terminal server, etc.)
via the Ethernet port. One of the following options can be selected:
Option
Description
P-MP Master
Mode
Allows the iPULSE radio to communicate
with an unlimited number of iPULSE radios
configured in P-MP Remote mode. The UDP
protocol is used for low latency serial data
transfer. This mode is extremely useful for
typical "polling" type protocols.
See the
information.
Summary of Contents for iPULSE R
Page 2: ......
