9. Warning messages and error codes
In the event of a device malfunction, the display shows the relevant information, warning and error codes.
9.1 Warning messages
The warning messages refer to the replacement of individual consumables.
The item to be replaced is highlighted in red, and the screens are displayed alternately.
Filter replacement screen
Mandatory inspection screen
9.2 Information messages
Screen about overpressure or
underpressure resulting from the natural
processes of cooling the chamber. It
can occur immediately after starting the
machine.
Message resulting from interruption of the
process after the sterilization stage - during
drying.
9.3 Error codes
The table below contains error codes that may appear when working with the
ENBIO S / ENBIO PRO sterilizer
No Error code
Description
Recommendations
1
"Chamber over
temperature"
Maximum chamber temperature
exceeded
Contact with the service
2
"Steam gen. Over
temperature"
Steam generator temperature too
high
•
Too high weight of sterilized instruments -
repeat the process with less instruments
(max. 0.5 kg S, 0.8 kg PRO)
•
Contact with the service
3
"Process over
temperature"
Process temperature too high
Contact with the service
4
"Overpressure error"
Pressure error
Contact with the service
5
"Sterilization pressure too
low"
Drying pressure too low
•
Check that there is water in the bottle
with the blue hose
•
Correct the position of the blue hose so
that the end is completely submerged
in water. Add a sinker to eliminate the
problem in the future
•
Check that the water supply hose (blue)
is not damaged (After correcting the
position / replacing the hose or refilling
with water, restart the machine)
•
Contact with the service
6
"Sterilization temp. Too
low"
Sterilization temperature too low
•
Check the water level in the bottle with
the blue hose
•
Check that the red tube is not pointing up
along its entire length, creating the so-
called air trap
•
Contact with the service
7
"Too high pressure during
drying"
Drying pressure too high
•
Make sure the red drain hose is not
immersed in water. The hose must not
be kinked, the liquid must flow down by
gravity
•
Check that the weight of the sterilized
instruments is not too high
•
Contact with the service
8
"Too many steam pulses /
no water"
Too many steam pulses. No feed
water.
•
Check the water connection to the "water
in" connector
•
Check the distilled water level in the feed
water tank (blue plug)
•
Check that the weight of the load does
not exceed the allowable weight.
•
Contact with the service
9
"Drainage error"
Clogged drain
•
Check the level of the wastewater and the
connection of the hoses
•
Check the level of the used water in the
bottle with the red cap. If the bottle is full,
discard the used water
•
Check that the red hose is not kinked and
that it is pointing downwards along its
entire length
•
Check that there is no debris in the outlet
opening (inside the chamber)
•
Contact with the service
48
49
