5
OPERATING THE UNIT
1.
Press the power switch to turn the power on. The LED Display will indicate a timer time
last set.
2.
Turning the ozone output adjuster
to adjust ozone output. The LED Display will
indicate Ozone output. There are 9 types:
The minimum ozone level is less than 40% of the max. output.
3.1
Using the Timer:
3.1a
Press the
key or the
key once to either increase or decrease the
timer time (01 03 05 10 20 30 40 50 60 70 80 90). Press repeatedly until you
reach the desired timer time. The maximum timer time is 90 min. The minimum
timer time is 0 min (displaying “00”).
3.1b
Press the
key to start working. The timer time starts blinking and
counting down in a 1-minute interval. When the timer time reaches “00” the
unit will stop. After 3 sec the LED will again indicate the timer time last set.
3.1c
To pause timing, press the
key
（
This will pause working too
）
. The
LED display will indicate the timer time last shown before the pause.
To resume timing, press
key again.
OR
To stop working immediately, switch the power switch to turn the power off.
To restart, repeat from the step1.
Note:
When the timer time is set at “00”,
key is not functioning.
To adjust the timer time during count-down either press on
or
key.
