4
Controls
Function
LED Display
Indicates Ozone output: 9 modes
Indicates timer time:00,01,03,05,10,20,30,…90 min
Indicates Constant-ON Mode: ON
ON/OFF
Press it to start working
Press it to stop working
Press and hold it for 3 sec to switch to Constant-On mode
UP
Each press increases the timer time by 10 min up to 90 min
DOWN
Each press decreases the timer time by 10 min down to 90 min
Ozone Output
Adjust
Each press increase the output from 40mg/hr to 200mg/hr by 20mg/hr up
BEFORE USE PREPARATION
1.
Ensure that all hoses are free from dust or other contaminants before connecting.
2.
Connect one end of 10 cm hose to an air inlet (either one) of Enaly Air Dryer.
3.
Connect the other end of 10 cm hose to the air inlet of the unit.
WARNING: Avoid using a hose longer than 10 cm to make the connection to Enaly Air
Dryer. An overly long hose can overload the internal air pump and cause a
premature failure.
4.1
For water/liquid treatments, connect the 1.20 m hose to the ozone outlet and a diffuser
stone to the other end of hose.
4.2
For air treatment, it is recommended to run without the hose connecting to the ozone outlet.
5.
Plug in the power plug into a power outlet.
WARNING: Use only the rated voltage indicated on the product information label. The
product information label is affixed on the case.
LED Display
Ozone Output
Adjust
ON/OFF
UP DOWN
