Enabling Technologies DYNAMIQUE, Initial Assembly

Page: 4 / 5

[4]
3) Set up the Seat.
See the image to the right for proper
setup.

The waist has two pads secured
with a ratcheting V-ladder.

The thigh has one pad secured
with a single ratcheting ladder

The seat angle adjustment has
two extension buckles at the
front of the thighs secured to two
single ratcheting ladders from the
seat back.
4) Remove and discard the
wooden dowels from the foot
and handle tubes.
The pin is not pinned through the
dowel. Remove the dowel first and
then remove the pin.
5) Install the Footrest.
Be careful to slide each side in
straight and at the same time. Slide /
tap the footrest into the tubes. If
necessary, a rubber mallet can be
used to overcome initial friction. If
necessary, tighten the ankle angle
adjustment clamps.
11) Install the handle.