Enabling Technologies Dynamique Biski, Owner'S Manual

Page: 36 / 44

[36]
If necessary, the Slide Slot
14
can be cleaned up using fine grit sand paper. To
better access the Slide Slot
14
, remove the Shifter Trigger
13
from the Shifter
Lever
12
with a 5/32” Allen tool and 7/16” wrench. Once free, move the
Shifter Trigger
13
to the enlarged end of the Slide Slot
14
and rotate the Shifter
Trigger
13
to remove it from the Slide
15
. If the Slide Slot
14
has been worn
beyond repair please contact us.
Step 6)
It is possible to inadvertently bend the Shifter Trigger
13
while cleaning snow
out of the ski.
To check if the Shifter Trigger
13
is bent:

Reinstall the gas struts
17
.

Keeping the ski raised up, shift the Shifter Lever
12
between its
“Load/Ski” and “Up” positions. If working properly the Slide
15
will
pivot back and forth with equal crispness.

Inspect where the Shifter Trigger
13
crosses within the Slide Slot
14
.
The Shifter Trigger
13
should cross approximately halfway.
Signs that the Shifter Trigger
13
is bent down:

The Shifter Trigger
13
crosses the Slide Slot
14
after halfway and
applies more pressure to the bottom side of the Slide Slot
14
.

The ski locks out when raised to the “Up” position, but when shifted
to the “Load/Ski” position the Slide
15
moves slowly, does not unlock
and prevents the ski frame from collapsing.

With the frame in its lowered position, the Shifter Lever
12
feels
notchy or difficult to shift into the “Up” position.
Signs that the Shifter Trigger
13
is bent up:

The Shifter Trigger
13
crosses the Slide Slot
14
before halfway and
applies more pressure to the top side of the Slide Slot
14
.

When raising the frame into the “Up” position, the Slide
15
moves
slowly and does not automatically lock out at the top.

With the frame raised up, the Shifter Lever
12
feels notchy or difficult
to shift into the “Load/Ski” position.