Fig.2
3.
The Tablet Holder comes with a set of 6 legs. The legs are different sizes to
allow for different sized tablets. Use the sizes that best fit for your tablet. To
install them on the holder body (see fig.3). Each leg slides on or off. Once this is
done you can now attach the Tablet Holder to the mounting arm (see fig. 4 & 5).
Fig.3
4.
Now that the Table Holder is fully assembled you can insert your tablet into the
holder by pushing down on the bottom spring-loaded support arms with the
tablet. Slide the top of the tablet under the top support arms until it fits snuggly
into the holder (see fig. 4).
Fig. 4
5.
You can now place the Tablet Holder on the end of the mounting arm. First back
off the set knob on the Tablet mount holder until it is flush with the inside of the
opening. This is necessary to allow the holder to be pushed all the way down on
the mounting arm post. The post at the end of the arm also has a flat spot, which
needs to be lined up with the set screw on the Tablet Holder’s base. Once this is
done you can tighten the set knob to lock the holder to the arm. Please Note:
Make sure to back the set screw enough to allow the Holder to be pushed all the
way down on the post of the arm, failure to do so will cause the Tablet Holder
and your Tablet to fall off the mounting arm and a fall could cause damage to
your Tablet. (See Fig. 5).
