The ultimate accessory!
The ultimate accessory!
The ultimate accessory!
The ultimate accessory!
Our terrific mounting system has three parts: a mounting platform, a light duty
mounting arm, and a clamp. The mounting platform is designed for easy access to
all of the iPad’s electronic ports. It also has two flexible cords to securely hold the
iPad. The light duty mounting arm expands from 14½" to 24" for maximum
flexibility and reach. The clamp allows you to easily mount the system to a
wheelchair or tabletop. Mounting System works with both iPad 1 and iPad 2. It is
also compatible with the iPad 1 case (#1555). Platform size: 10¾"L x 9½"W x
1½"H; Arm size: expands from 14½"L to 24"L.
1.
Mounting Arm Assembly:
Mounting Arm Assembly:
Mounting Arm Assembly:
Mounting Arm Assembly: Your mounting system consists of three main parts,
an adjustable arm, iPad mounting plate and a clamp. First you will need to
assemble the 3 main parts. To attach the clamp to the arm, loosen the set
screw on the clamp (see Fig. 1). Next depress the Silver Spring loaded locking
pin, then push one of the ends of the mounting arm into the clamp(see Fig. 2)
Please Note: you need to line up the flat part of the Mounting Arm end post
with the set screw in the clamp. This will prevent the arm from spinning freely
inside the clamp. Once this is done you can tighten the setscrew to lock the
Mounting arm to the clamp.
Fig. 1
2.
Clamping Options:
Clamping Options:
Clamping Options:
Clamping Options: Our mounting clamp is designed for mounting to tubular
(wheelchair, bedrail, walker, etc.) or flat surfaces such as a table top or desk.
For flat surface mounting use the included wedge insert shoe stored in front
of the locking knob on the clamp (see Fig.2) Loosen locking knob slightly to
remove wedge, tighten knob once wedge has been removed.
Fig.2
3.
At this point we recommend you place your mounting arm without the iPad
holder and do a rough setup, you can fine tune your adjustments after you
have placed the iPad holder on the arm. Do not force or try adjusting the arm
without first loosening the set knobs for that portion of the arm. Each section
of the arm has a set knob. Once you have the arm in the desired position you
can tighten the knobs to lock the arm in place.
4.
Once the arm is in position you can now place your iPad and holder on the
arm. First back off the set knob on the iPad mount holder until it is flush with
the inside of the opening. This is necessary to allow the holder to be pushed
all the way down on the mounting arm post. The post at the end of the arm
also has a flat spot, which needs to be lined up with the set screw on the iPad
holder’s base. Once this is done you can tighten the set knob to lock the
holder to the arm. Please Note: Make sure to back the set screw enough to
allow the holder to be pushed all the way down on the post of the arm, failure
to do so will cause the iPad to fall off the mounting arm and a fall could cause
damage to your iPad. (See Fig. 3).
Fig. 3
Rev 2
Rev 2
Rev 2
Rev 2/2
/2
/2
/2/1
/1
/1
/17
7
7
7
Tighten
Clamp
Locking
Knob
Tighten Set
Knob
