CHANGING THE MODE
CHANGING THE MODE
CHANGING THE MODE
CHANGING THE MODE: 1. Turn on the iPad Wireless switch 2. Press and hold the MODE
button for 2 seconds. The red LED will flash once per second from 1 to 6 flashes. The number
of flashes corresponds to the same MODE number. Be sure to count the flashes. 3. Release
the MODE button following the number of flashes that reflects the desired MODE. The orange
LED will flash the number of times indicating which MODE has been set. Example: To set
MODE 2 hold the MODE button for 2 flashes of the red LED, release and the orange LED will
flash 2 times to confirm the MODE 2 setting. Note: Once the MODE has been set, it will
remain the same until it is changed following the above steps. KEY REPEAT FUNCTION To turn
on the Key Repeat function, hold down buttons 2 and 4 together. Once you have turned it on,
holding down a pedal or button, (except button 6) in any MODE for more than two seconds will
repeat the key action twice per second until released. Variances may occur in the repeat
timing due to environmental factors.
Charging:
Charging:
Charging:
Charging:
Important:
Important:
Important:
Important: Please charge your iPad Wireless switch before using it the first time. Use the
enclosed USB cable with a wall power adapter (Not Included), or connect it to your USB port
on your computer. A full charge will need approximately 2 hours with a wall adapter and 6
hours through a computer. Your iPad Wireless switch should last 80-100 hours on a full
charge depending on how much you use it. On a full charge, the LED will blink green. When the
power is low, the LED will blink as follows: Yellow
Yellow
Yellow
Yellow every second = under 25% power Red
Red
Red
Red every
second = under 10% power Charge your unit through the mini USB port with the cable
provided, attaching the other end to any powered USB port on a computer or with a USB wall
charger. Depending on the source of power, it will take 1-6 hours for a complete charge. Note
that if the iPad Wireless switch is turned off while charging, the LED indicator will not light up.
If you leave the iPad Wireless switch on while it is charging, the LED will remain lit and you can
monitor the charging status. Red
Red
Red
Red is a low charge, yellow
yellow
yellow
yellow is 75% charge and orange/green
orange/green
orange/green
orange/green is
a full charge. Note, that the unit will still charge while turned off. Note:
Note:
Note:
Note: If you fail to charge
If you fail to charge
If you fail to charge
If you fail to charge
your battery when it begins blinking red, you risk running it down completely which will
your battery when it begins blinking red, you risk running it down completely which will
your battery when it begins blinking red, you risk running it down completely which will
your battery when it begins blinking red, you risk running it down completely which will
require a factory replacement.
require a factory replacement.
require a factory replacement.
require a factory replacement.
1.
Turn off the iPad Wireless switch.
2. On the device, go to the Bluetooth settings (Settings, General, Bluetooth). Tap the
Wireless Interface serial number in the Bluetooth list. Tap the "i" in the blue box to the
right, then tap Forget this Device and then Okay. (If the Wireless Interface serial
number is not showing, skip this step)
Page 3
Page 3
Page 3
Page 3
