EMX Industries, Inc.
Tech Support: 216-518-9889
3/5
CHIME-100_Rev1.1_022421 [email protected]
4.
Wire all needed connections on the device. See sections “Outputs” & “Inputs” for a detailed
description of each terminal’s function. The CHIME-100 requires a connection between
INPUT 1
and
INPUT 2
to properly function.
Connection
Description
VOUT -
Negative connection from power jack in. Can be used to power other
low-power devices. (Power adapter included is 9VDC)
VOUT +
Positive connection from power jack in. Can be used to power other
low-power devices. (Power adapter included is 9VDC)
INPUT 1
Closing the connection between these inputs will trigger the melody.
It can be connected to a relay, switch, pushbutton, transistor, etc.…
INPUT 2
NPN OUT
An open collector transistor output which will pull down to ground
when activated. This output can handle 170mA at 100VDC
RE
LA
Y
O
U
T
NC Normally-closed output connection
COM Common output connection
NO Normally-open output connection
5.
All wiring should pass through the cable grip. Tighten down the cable grip once wiring is complete.
6.
Check that the inputs are being properly recognized. The red
Presence LED
(see below) will turn
on when the input is activated. If the input shorting lasts longer than 30 seconds, the presence
LED will begin blinking.
7.
Configure the CHIME-100 to play the desired melody by pressing the pushbutton on the side of
the unit. Adjust the volume to a comfortable level. See section
“Chime Adjustment”
on next page
for more information.
8.
Reattach the lid to the base and screw down firmly. Test the setup again to ensure the correct
chime plays at a comfortable listening level.
Presence LED
