Torque wrench DEU
10
Operating instruction edition: 01.04.2018
correct
wrong
correct
wrong
wrong
3 Handling
Type A3 with torque range 70-700 Nm:
-
First push the handle extension in the holding pipe of the torque wrench. Make
sure the pin of the handle extension engages in the bore of the torque wrench.
All types:
-
Adjust main pointer to
„0“ by twisting the scale at the housing until the main
pointer is flush with the
„0“-position of the scale.
-
Adjust drag pointer to
„0“ against the measuring direction.
-
Put the according intermediate piece and/or socket wrench onto the square
adaptation of the torque wrench.
-
Put the torque wrench with the intermediate piece on the square pin.
Measure the torque. The starting tightening power must be introduced at the
marking, see picture.
Attention
The load direction must be in right angle against the torque wrench, in horizontal
and vertical direction (tolerance ±15°)
"0"-Position
Main pointer
