4
3.
Telephone Switch ON-OFF – captures and holds telephone line allowing you
to hang up the phone without losing the call – connects EJ-10 to phone line.
4.
Audio Input – lowest lever input used to drive phone line (8 Vp-p) minimum
buffered stereo – for weak signal to microphone out – also highest level
output from phone line input.
5.
Stereo Input – accepts stereo line level audio signal input – 1 volt RMS to
microphone – or 25 Vp-p signal to phone line.
6.
Loudspeaker Level Input – accepts speaker level signals up to 10 volts RMS
and provides a power load 10 ohms – 10 watts for lowest distortion and noise.
7, 8 & 10. Mono RCA, 1/8” Mini & 1/4” Phone Auxiliary Line Level Inputs – accept
line level 1 volt RMS input – buffered inputs allow up to six different inputs
at the same time.
9.
Cords Clip – patch cords are clipped to the EJ-10’s box so they won’t get lost.
Clip can be removed to add or subtract patch cords.
11.
Hum Switch – connects the shield ground from inputs to output allowing a
selection for lowest hum pick up.
12.
Volume Control – controls signal volume in any of 4 signal directions:
a) Inputs to Microphone Out
b) Phone In to Microphone Out
c) Phone Input to “Audio Input (Output) No. 4” connector (used for
recording)
d) Inputs to Phone Out
13.
Output Cord to Microphone Input (XLR) – buffered isolated microphone level
signal out to: microphone input jack of the sound system, microphone wall
jack, existing P.A., sound reinforcement system, or house sound system.
14.
Basic Use Instructions Operations & Examples – quick reference operations
Examples displayed on front of EJ-10’s.
