Linking through the cable is always engaged. If you'd like to link
using the enclosure set the
'Link through rack'
dip switch to the
'on'
position. By having this dipswitch off (default), the unit
won't interfere with any other units you may have linked in your
rack. (Typically, racks link with pin 6 on the card edge
connector).
High Pass Filter
The high pass filters cut out low frequencies in the side-chain
below either 120hz or 220hz. Good uses for this would be:
- Engaging the 120hz filter on bass will allow you to smooth out
the mid-range without over-compressing the lower notes.
- The 220hz filter is useful on instruments like chugging guitar
or other low mid instruments to avoid the pumping effect.
Summary of Contents for ECM-519
Page 1: ...compressor ECM 519 ...
