Empire EMT-7R, Instruction & Parts Manual

Page: 5 / 46

ELECTRICAL INSTALLATION
EMT-7R Power Rotary Machine Must Be Installed By a Certified Electrician
Please see wiring schematics for proper location to run your power lines to.
(
FAILURE TO WIRE ACCORDING TO WIRING SCHEMATICS WILL RESUT IN INVERTER DAMAGE)
ROLL INSTALLATION
The EMT-7R comes with a lower shaft adjustment (14) so rolls with differing centerlines can be lined
up. Loosen the locking screw on the right hand side of the unit (12) and then bring the rolls together.
Once the rolls have fit snugly together firmly lock the shaft in place.
THROAT GAUGE ADJUSTMENT
The EMT-7R is fitted with adjustable Throat Gauge Guides. For operation of machine where limited
throat gauge depth is required the guides should be located to the front of the of the shafts. Where
deeper operations are required the Throat Gauge Guides must be removed and placed in their proper
locations near the back of the shafts.
DEPTH CONTROL
The EMT-7R comes standard with a manual screw adjustment for control of the upper shaft depth. (9).
If you look directly behind the Adjusting Screw you will see the Upper Shaft Tensioning Screw (10).
This is factory set and should never need adjustment.
ROLL INSTALLATION
Rolls must be secured by means of the Roll Locking Nuts (5) provided.
Upper Roll Lock Nut is Left Hand Thread and the Lower Roll Lock Nut is Right Hand Thread.
Failure to secure rolls will result in roll and shaft damage and will void all factory warranties.
EMT-7R comes with a set of 3/8” Single Bead Rolls as standard.
(We will quote on any roll application you may require)
SPEED CONTROL
Your EMT-7R is equipped with a Speed Control and Forward/Reverse Switch. Forward/Off/Reverse
Switch must be in either Forward or Reverse position to operate. Machine will only run if foot pedal is
depressed. Operator should never switch between forward and reverse while the rolls are turning as
damage may occur. Speed may be adjusted while rolls are turning.