37402-5-0620
Page 13
DVC-35SPP STANDING PILOT LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone, Follow the gas supplier’s
instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it; call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read safety information above.
2. Turn off all electric power to the appliance.
3. Remove control access panel (lower front panel).
4. Turn gas control knob clockwise
to “OFF.”
5. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow “B” in the safety information above. If you don’t
smell gas, go to the next step.
6. Remove the pilot access cover located on the combustion
chamber.
7. Find pilot - follow metal
tube from gas control.
The pilot is located
between the two burner
tubes behind the pilot
access cover.
8. Turn gas control knob counterclockwise
to
“Pilot.”
9. Push and hold red reset button down completely and
repeatedly push the ignitor button until the pilot burner
is lit. Pilot may also be lit with a match. Continue to hold
the red rest button down for about one (1) minute after
the pilot is lit. Release button and it will pop back up. Pilot
should remain lit. If it goes out, repeat step 4 through 9.
• If button does not pup up when released, stop and
immediately call a qualified service technician or gas
supplier.
• If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your service
technician or gas supplier.
10. Replace pilot access cover.
11. Turn gas control knob counterclockwise
to
“ON.”
12. Replace control access panel (lower front panel).
13. Turn on all electric power to the appliance.
GAS CONTROL KNOB SHOWN IN “OFF” POSITION
THERMOCOUPLE
PILOT BURNER
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to appliance if service is to be
performed.
2. Remove control access panel (lower front panel).
3. Push in gas control knob slightly and turn
clockwise to “OFF.” Do not force.
4. Replace control access panel (lower front panel).
WARNING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
