![background image](http://html1.mh-extra.com/html/empire-comfort-systems/p-6/p-6_installation-instructions-and-owners-manual_2403973043.webp)
31447-5-0214
Page 43
LOG PLACEMENT (4 LOG SET)
Before you begin: This fireplace is supplied with a set of four
ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water
to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace. Please refer to
Figure
65, Figure 66,
and
Figure 67
and corresponding
WARNING,
when
completing the following log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of firebox
4. Place rear (#1) log onto two pins on rear log support.
5. Place left, front (#2) log onto two left, front pins on burner pan.
6. Place right, front (#3) log onto two right, front pins on burner
pan.
7. Place Branch (#4) onto one pin on rear log and one pin on front
left log.
8. Place decorative rock in front of grates and sides of main burner.
ATTENTION
: Do not place decorative rock on logs or on burner.
The decorative rock should only be placed on the fireplace floor.
9. After all logs are properly positioned, place small “dime” size
pieces of Rockwool lightly across the front round “blue flame”
ports. Place the ember material (Rockwool pieces) side by side.
Do not stack more than one layer of embers across the burner
ports.
See Figure 58.
10. Replace glass door onto firebox.
11. Secure the two glass frame spring clamps at bottom of firebox.
12. Align the tabs on top louver brackets with slots in front posts to
secure top louver..
13. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
Figure 65
Figure 66
WARNING
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
Attention:
Do not use
Figure 66
or
Figure 67
to order logs. Refer
to parts view on page 66 and parts list on page 65 to order logs and/
or ember material for your appropriate fireplace model.
Figure 67
Log Set Parts List
Index
Number
Part
Number
Description
1
R10349
Rear Log
2
R10350
Front Left Log
3
R10351
Front Right Log
4
R10352
Top Branch
WARNING
If flame lifts off burner and goes out, verify insulation and
retainer were removed. See page 15.
Summary of Contents for P)-6
Page 20: ...31447 5 0214 Page 20 Figure 29 Figure 30 Figure 31 EXAMPLES TOP VENT RUN...
Page 37: ...31447 5 0214 Page 37 Figure 57 DVVK 4FV DIRECT VENT TERMINATION KIT continued...
Page 46: ...31447 5 0214 Page 46 Figure 70 MILLIVOLT SYSTEM STANDING PILOT WIRING DIAGRAM...