27825-2-0811
Page 10
In planning the installation for the fireplace, it is necessary to
determine where the unit is to be installed and whether optional
accessories are desired. Gas supply piping should also be planned
at this time.
The fireplace can be mounted on any of these surfaces:
1. A flat hard combustible or non-combustible surface.
2. A raised platform of combustible or non-combustible material.
3. Four (4) corners of the fireplace so contact is made on all four
perimeter edges on the bottom of the unit.
(Example: Four (4) concrete masonry blocks.)
If the fireplace is installed directly on carpeting, tile or other
combustible material other than wood flooring, it should be installed
on a metal or wood panel extending the full width and depth of the
unit.
At this point, you should have decided what components to include
in your installation, and where the fireplace is to be located. If this
has not been done, stop and consult your dealer for assistance
with this planning.
This fireplace is intended for installation on an outdoor patio or
in your yard. This fireplace shall be used only outdoors in a well
ventilated space and shall NOT be used in a building, garage, or
other enclosed area.
It is recommended that this fireplace be installed in a “sheltered”
area. Direct wind will cause an erratic flame and possible pilot or
main burner outage. This erratic flame could also lead to excessive
black soot. These issues are nuisance issues rather than a safety
issues.
Typical installation may include covered patio, screened porch,
gazebo or an outside wall of a house.
Minimum porch area – 96 square feet
•
Minimum ceiling height – 82 inches
•
Minimum of two walls to be open or screened to the following
guidelines.
Minimum screen area – 64 square feet
•
Minimum top of screen height (side walls) – 70 inches
•
Installing the Hood
A stainless steel hood is furnished with each outdoor fireplace. The
hood MUST be installed before the fireplace is used. Failure to do
so may create a possible fire hazard.
Finishing
Hearth extensions are recommended, not a requirement for these
gas fireplaces.
Figure 5
Cleaning Instructions
This appliance is built using mostly high-grade stainless steel to
resist rust-through. In outdoor applications, all stainless steel will
develop a dull patina and, depending on the local environment
and on the materials used in the installation, may develop some
surface oxidation (rust). This does not affect the performance of
the fireplace, and does not require any action to correct. If you
prefer keeping your fireplace front looking factory-fresh, clean it as
required with stainless steel cleaner.
When installation application includes highly acidic applications
such as mortar or stone etching, do not remove the protective PVC
film from the stainless steel until after this application is complete.
Once the film has been removed we recommend that the appli
-
ance be cleaned with a stainless steel cleaner immediately.
Please note that areas where the film has been formed (corners,
hems, etc.) may require extra cleaning due to the properties of
the film. Ensure that all protective film has been removed from the
fireplace prior to burning the appliance.
pLANNING INSTALLATION
