38142-2-0719
Page 15
Figure 19
Attention: Do not use
Figure 19
or
Figure 20
to order logs.
Refer to parts view on page 37 and parts list on page 36
to order logs and/or ember material for your appropriate
fireplace model.
#4 - TOP BRANCH
#1 - REAR LOG
#3 - FRONT
RIGHT LOG
#2 - FRONT
LEFT LOG
Figure 20
Before you begin: This fireplace is supplied with a set of
four ceramic fiber logs. Do not handle these logs with your
bare hands. Always wear gloves to prevent skin irritation
from ceramic fibers. After handling logs, wash your hands
gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation
of this fireplace. Sooting and other problems may result
if the logs are not properly and firmly positioned in the
fireplace. Please refer to
Figure 18, Figure 19, and Figure
20
and corresponding WARNING, when completing the
following log placement steps.
1. Place rear (#1) log onto two (2) pins on rear log support.
2. Place left, front (#2) log onto two (2) left, front pins on
burner pan.
3. Place right, front (#3) log onto two (2) right, front pins
on burner pan.
4. Place Branch (#4) onto one (1) pin on rear log
5. Place decorative rock in front of grates and sides of
main burner.
6. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front round
"blueflame" ports. Place the ember material (Rockwool
pieces) side by side. Do not stack more than one layer
of embers across the burner ports.
See Figure 18.
EMBER
PLACEMENT
REAR LOG
LOCATOR TABS
FRONT LOG
LOCATOR PINS
Figure 18
ATTENTION: do not place decorative rock on logs or
on burner. The decorative rock should only be placed
on the fireplace floor.
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property
damage or personal injury.
LOG PLACEmENT (4 LOG SET)
f i r e - p a r t s . c o m