41485-0-0120
Page 3
Proper Log Placement
Log placement is critical to proper burner performance. Logs must
be correctly positioned. The photos in this manual show the proper
position for logs in this set. Owners need to be shown proper log
placement and instructed not to move the logs.
Proper Placement of Crushed Glass Media
This fireplace is designed to use crushed glass media on the burner.
The maximum amount of crushed glass media should not exceed
6 Sq. Ft. Spread out over the entire burner and burner screen. It is
recommended that the crushed glass media be added after the log
has been properly installed.
CAUtIoN
Do not place crushed glass around the pilot assembly.
Crushed glass is only to be placed on the burner screen
and burner cover.
Make Owners Aware of Proper Log Set Operation
Properly installed and properly maintained log sets should not
deposit soot on the logs. If users see excessive soot appearing
on a log, call for service. Do not continue to operate the fireplace.
IMPortANt INStALLAtIoN gUIDeLINeS
Qualified Installing Agency
Installation and replacement of gas piping, gas utilization equip
-
ment or accessories and repair and servicing of equipment shall be
performed only by a qualified agency. The term "qualified agency"
means any individual, firm, corporation, or company that either in
person or through a representative is engaged in and is responsible
for (a) the installation, testing, or replacement of gas piping or (b) the
connection, installation, testing, repair, or servicing of equipment;
that is experienced in such work; that is familiar with all precautions
required, and that has complied with all the requirements of the
authority having jurisdiction.
The installation must conform with local codes or, in the absence of
local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA54
.*
*Available from the American National Standards Institute, Inc. 11
West 42nd St., New York, N.Y. 10018.
geNerAL INforMAtIoN
Commonwealth of Massachusetts:
The installation must be
made by a licensed plumber or gas fitter in the Commonwealth
of Massachusetts.
Sellers of unvented propane or natural gas-fired supplemental
room heaters shall provide to each purchaser a copy of 527 CMR
30 upon sale of the unit.
Appliance Certification
This logset is design certified in accordance with American National
Standard/CSA Standard ANSI Z21.88/CSA 2.33 and by Underwrit
-
ers Laboratories for use with a Direct Vent Gas Fireplace Heater
and shall be installed according to these instructions.
Summary of Contents for LS55CD-1
