38616-0-0218
Page 19
LOG PLACEMENT - LS(24,30)CD
Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Refer to Figure 2 for the following warning.
WARNING
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
LS(24,30)CD
REAR LOG SUPPORT
A
B
C
E
D
F
G
H
I
J
Figure 2
ATTENTION
: Do not use
Figure 2
to order replacement logs.
Refer to Log Identification LS24CD on Page16 or Log Identification
LS30CD on Page 17 for your appropriate model number.
The following
WARNING
applies when log set is installed onto an
unvented gas burner assembly.
WARNING
This appliance is equipped for natural or propane gas. Field
conversion is not permitted.
Apply glowing embers per the ember placement section of this
manual on page 30. Replace glowing embers with appropriate part
number from the table below from Empire Comfort Systems, Inc.
Application of excess glowing embers may adversely affect perfor
-
mance of the heater.
WARNING
All previously applied loose material must be removed prior
to reapplication.
Replacement Loose Material
(glowing embers)
Part
Number
LS24CD
15970
LS30CD
15970
Platinum Bright Embers
PE20-1
NOTE:
A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with production
embers) to the burner. As you add platinum embers, remove a like
amount of standard embers. The total amount of embers must not
exceed the amount provided with the burner. Tear the embers into
dime-size pieces and pull them open to reveal as much surface
area as possible.
Please See Our Website For Log Assembly Videos.
