![background image](http://html1.mh-extra.com/html/empire-comfort-systems/dvx36dp31n-2/dvx36dp31n-2_installation-instructions-and-owners-manual_2404103076.webp)
28653-2-0811
Page 76
ACCENT LAMP
12 VOLT SIDE
120 VOLT SIDE
Your Luxury Direct Vent Gas Fireplace comes equipped with our
"Accent Lamp." The light has been pre-wired and is controlled from
the Rheostat.
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the Accent Lamp/transformer from the junction box
inside the fireplace.
2. Remove the four screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
Note:
Do not handle the lamp (bulb) with bare fingers, protect with
clean dry cloth.
The lamp will pull straight out of the socket. Replace with 10 Watt/12
Volt Halogen bulb.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
Figure 84 - Accent Lamp Wiring
COVER
LAMP
GLASS
GASKET
BEZEL
Figure 85 - Accent Lamp Parts
1. Using gloves, unpack liner components and check for damaged
or missing components.
2. Lower bottom louver and remove upper louver on fireplace.
3. Remove glass frame assembly from fireplace.
4. Remove rear logs from burner assembly.
5. Place brick panel (rear) against rear wall in fireplace.
Note: The top edge will have a half-moon cutout relief to match
up with the rear flue vent hole.
6. While holding finished edge on brick panel (side), place brick
panel (sides) against side walls in fireplace. Move side panels
rearward until the back edge meets the rear brick panel. Slide
side brick panels down so they rest on firebox bottom.
7. Align grout lines on top brick panel with the grout lines on the
side brick panels. Place the top brick panel into brick panel
holder. With needle-nose pliers, carefully bend hold-down tabs
on brick panel holder over the edges of the top brick panel. The
hold-down tabs will securely hold the top brick panel in place.
8. Replace rear logs onto burner assembly. (Refer to log placement,
pages 40 to 44.)
9. Attach glass frame assembly onto fireplace.
10. Raise bottom louver and replace top louver onto fireplace.
11. Installation of optional brick liner is complete.
BRICK LINER INSTALLATION INSTRUCTIONS