24032-2-1008
Page 13
ADJUSTING AIR SHUTTER
The air shutter has been factory set to the optimum performance
level for this appliance. LP air shutter is not adjustable.
1. Remove cast iron top and carefully set aside.
2. Remove cast iron front and carefully set aside.
3. Carefully remove glass door. See Figure 10.
4. Carefully remove logs and set aside.
5. Remove the log shelf by removing the (2) screws securing the
log shelf to the rear wall. See Figure 11.
6. Remove the burner by removing the (2) screws at the front of
the burner as shown in figure 12.
7. Carefully remove the burner by lifting straight up.
8. Loosen the (2) nuts on the air shutter shown in figure 12 to
adjust the air shutter. Figure 13 call-out demonstrates the proper
locations for NAT gas. LP Air shutter is not adjustable.
9. Tighten the (2) nuts back down locking the air shutter in place.
Be sure that the air shutter is the same distance from the burner
orifice on both sides of the air shutter for proper burner fit
up.
10. Carefully replace the burner by dropping it down over the
orifice holder and air shutter lining up the front mounting holes
with the holes on the firebox.
11. Replace the (2) screws at the front of the burner shown in
figure 12.
12. Replace the log shelf by replacing the (2) screws securing the
log shelf to the rear wall. See Figure 11.
13. Replace logs. See page 21.
14. Carefully replace glass door.
15. Replace cast iron front.
16. Replace cast iron top.
Note:
Be sure air shutter is adjusted and tightened evenly to
ensure proper fit, failure to evenly adjust air shutter can cause
improper combustion. Only a certified technician should adjust
the air shutter.
Figure 12
Figure 13
LOOSEN (2) NUTS
DIM. “A”
DIM. “A”
NAT
9/16”
LP
1”
SHOWN WITH TOP & FRONT REMOVED
GLASS FRAME
ASSEMBLY
LATCH GLASS FRAME
WITH 2 GLASS FRAME
CLAMPS
Figure 10
Figure 11
