![background image](http://html.mh-extra.com/html/empire-comfort-systems/dv25in33ln-3/dv25in33ln-3_installation-instructions-and-owners-manual_2404052021.webp)
35657-4-1015
Page 21
LOG PLACEMENT
Before you begin: This fireplace insert is supplied with a set of
seven ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from ceramic
fibers. After handling logs, wash your hands gently with soap and
water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace. Refer to
Figure 18
and
Figure 19
and corresponding WARNING when completing follow
-
ing log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of the glass
door assembly.
4. Swing the bottom of the glass door outward approximately
10-15 degrees, then grasping the edges, gently lift upward to
remove the door assembly, and set aside.
5. Remove the foam packaging that contains the log set from
inside the firebox.
6. Carefully unpack the logs and twigs. Spread them out for easy
identification.
Note: Continue to pages 21-29 for step by step instructions
with images.
Figure 18
WARNING
Failure to position the parts in accordance with this dia-
gram or failure to use only parts specifically approved with
this appliance may result in property damage or personal
injury.
Figure 19
NOTICE
:
Center the front two logs on the front log support ledge.
Then make sure they are positioned all the way forward and
touching the back edges of the grate tang uprights. The bottom
of the two front logs are flat and must sit on top of the front log
support ledge.
CAUTION
Decorative Rock is not included with the Fireplace Insert,
however it may be purchased separately and placed only on the
firebox floor. Do Not place decorative rock or rock wool on the
logs or burner assembly.