22679-1-0408
Page 15
Attention: Do not use Figure 61 or Figure 62 to order logs. Refer
to parts view on page 57 and parts list on pages 58 and 59 to
order logs and/or ember material for your appropriate fireplace
model.
Before you begin: This fireplace is supplied with a set of three
ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water
to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please
refer to
Figure 18, Figure 19, and Figure 20
and corresponding
WARNING, when completing the following log placement
steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of
firebox
4. Place rear (#1) log onto two (2) pins on rear log support.
5. Place left, front (#2) log onto two (2) left, front pins on burner
pan.
6. Place right, front (#3) log onto two (2) right, front pins on
burner pan.
7. Place Branch (#4) onto one (1) pin on rear log
8. Place decorative rock in front of grates and sides of main
burner.
9. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front round
"blueflame" ports. Place the ember material (Rockwool
pieces) side by side. Do not stack more than one layer of
embers across the burner ports.
See Figure 18.
10.
Replace glass door onto firebox.
11. Secure the two glass frame spring clamps at bottom of
firebox.
12. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
13. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
Figure 19
Figure 18
Figure 20
ATTENTION: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property damage
or personal injury.
loG plACemenT (4 loG seT)
#4 - TOP BRANCH
#1 - REAR LOG
#3 - FRONT
RIGHT LOG
#2 - FRONT
LEFT LOG
EMBER
PLACEMENT
REAR LOG
LOCATOR TABS
FRONT LOG
LOCATOR PINS
