35651-0-0615
Page 11
You must secure the gas burner to the fireplace floor. If
not, the entire unit may move when you adjust the controls.
Movement of unit may cause shifting of the gas logs which
leads to sooting and improper burning. Grate movement
could cause a gas leak.
Special care is required if you are installing the unit into a
sunken fireplace. You must raise the fireplace floor with non-
combustible material to allow access to gas log controls.
This will ensure adequate air flow and guard against sooting.
Raise the fireplace floor using noncombustible materials.
Assembly Procedure:
1. Place the burner in the fireplace or firebox. Make certain the
entire ember burner is inside the front edge of the fireplace
or firebox.
2. An anchor hole is provided in the two bottom side members
of the grate frame. After centering the grate correctly, mark
the hole positions on the fireplace/firebox floor. Drill two 5/32-
in. diameter holes approximately 1-1/2” deep for masonry
screws or 1/8-in. hole for sheet metal screws.
3. Anchor the grate to the fireplace/firebox floor using the
screws provided. Refer to Figure 4.
Proper installation of the grate is essential to prevent any
movement of the gas logs and controls during operation.
Figure 4
BEFORE FULLY INSTALLING THE APPLIANCE
