Pan dimensions
inches (mm)
Wok burner
12000Btu/hr
Rapid burner
10200Btu/hr
Semi rapid burner
6000Btu/hr
Auxiliary burner
3400Btu/hr
Outside diameter - top
≤
9 (229)
≤
9 (229)
≤
7 (178)
≤
7 (178)
Projected outside
diameter - bottom
≤
8
½
(216)
≤
8
½
(216)
≤
6
½
(165)
≤
6
½
(165)
WARNING:
As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid
simmering. If the control knobs become difficult to turn, please contact your local service center.
WARNING:
Users could not use the cooking vessels on the hotplate that overlap its edges.
WARNING:
All burner caps can
’t be dislocated installation, otherwise it will lead to flash back on the
upper aluminum seats and cause the upper aluminum seats to melt and deform, see below figures for
correctly placing the burner caps
Figure 5
Re-ignition:
If the flame goes out for some reasons, the re-igniter device will automatically start the ignition function,
and will not stop the ignition until the burner ignites. If the burner is not ignited, turn the switch to the off
state and check whether there is gas in the gas pipe. Under normal air supply, turn the switch to the
"maximum flame" position, and then ignite again. Wait for 30 seconds when igniting; because there is
air in the gas appliance, there may be unsmooth ignition, turn the switch to the "maximum flame"
position and ignition again.
Maintenance and Cleaning
Before any maintenance or cleaning can be carried out, you must DISCONNECT the gas cooktop from
the electricity supply.
The gas cooktop is best cleaned while it is still warm; as spillage can be removed more easily than if it is
left to cool.
7