Emotron EMX-B, Instruction Manual

Page: 20 / 60

16 Mounting and installation
CG Drives & Automation 01-6048-01r3
2.4 Control board
Fig. 5 and Fig. 6 shows the layout of the control board and where the parts most
important to the user are located.
For safety reasons do not make changes while the mains supply is on, see also
“Safety instructions” on page 1.
Fig. 5 Control board layout
EMX-B15
.
Table 2 Location of terminals and components
EMX-B15
.
No. Designation
1 Three LED operation indicators
2 DIP switches
3 Test switch
4 Jumper SW2 to select signal type, voltage or current (K/I)
5 Control signal terminals and RS485 interface (31-40)
6 Alarm terminals (41-43)
7 Hall sensor terminals (1-5)
8 Motor terminals ( -R-Y-B)
9 Mains supply terminals (L-N- )
10 PE connector
1
2
3
4
9 8 7
6 5
10