Emos P0067, Manual

Page: 4 / 24

4
• Each pair of buttons works separately. The left-side buttons turn the corre-
sponding socket on, the right-side buttons turn it off.
• The red LED light indicates signal transmission.
Replacing the Battery in the Remote Controller
• Open the battery compartment cover at the back of the remote controller.
• Remove the used battery.
• Insert a new CR2032 3 V battery. Make sure you observe the correct polarity.
Use primary batteries only, not rechargeable ones.
• Close the cover.
Pairing
• Connect the receiver to mains power.
• Press and hold the ON button on the desired button row of the remote controller.
• The devices are now paired.
Cancelling Pairing
• If you wish to cancel pairing, you must first unplug the receiver and plug
it in again.
• Then, press the OFF button on the row you wish to unpair and hold it for
30 seconds.
• The device is now disconnected from the remote controller.
• If you wish to pair the device again, you must first unplug and replug the
receiver.
Important Warning
• Only a lead-in cable (not an appliance with a direct plug) can be plugged
into the remote-controlled socket.
• The remote-controlled sockets must be connected to a 230 V AC/50 Hz
power grid fitted with circuit protection.