Installation of video monitor wall-mount frame
1. Mark the holes of the frame on the wall and drill the holes.
2. Drill the hole into the wall in the middle of the frame for all cables coming to monitor (camera unit cable
and cable from power supplier, etc.).
3. Fix the frame with wall plugs and screws.
System connection
Wire the outdoor camera unit to the monitor by plugging the cable into descripted connections.
Video monitor fitting
1. Press the monitor to the frame.
2. Push the monitor down.
Connection to the mains power
1. Plug the power supplier to the mains 230V/ 50Hz.
2. Plug the power supplier connector into the descripted connection onto the monitor.
3. When power is present on the video monitor the LED will be lit on the monitor.
Wiring diagram of video phone system
Requirements on cabling of the system
Video door phone system uses 4 core cables. Maximal distances between camera unit and monitor with
regards to the cross sectional area (CRA) of the wires is show in the following table.
In the areas with high possibility of interference it is recommended to use a 75 Ohm coaxial cable for
connection of video signal.
