6
Manual Setting of Time, Date
Note: pressing of each button is accompanied by a beep (cannot be deactivated).
1. Long press the
button.
2. Use the
/
buttons to set the following parameters: year – month – day – hour – minute –
12/24 h time format – time zone – calendar language (GER, FRA, ITA, NLD, SPA, DAN, ENG) – weather
forecast icon – pressure value.
Note: The set icons for the weather forecast and pressure value are only approximate and are used only as
secondary settings.
You can move between the individual values by pressing
.
Holding the
/
button accelerates the setting of values.
If no button is pressed within 20 seconds, the unit will revert to the basic display.
Alarm Settings
The weather station allows you to set 2 separate alarm times.
Repeatedly press the
button and select alarm time no. 1 (AL1) or alarm time no. 2 (AL2).
Then, repeatedly press the
button to set the alarm for weekdays (
) or weekends (
) or both.
Then, long press the
button and set the desired alarm time.
You can set the time values by repeatedly pressing
/
.
To confirm the hour/minute value you set, press the
button.
Based on the settings, the display will show an icon of the corresponding alarm (
,
).
The alarm will then sound at the set time.
If you wish to deactivate the alarm, repeatedly press the
button.
The alarm icons will not be shown on the display.
Snooze Function
Alarm ringing can be postponed by 5 minutes using the SNOOZE/LIGHT button located on the top
part of the weather station.
Press the button when the alarm starts ringing. The alarm icon and
will be flashing.
To cancel the SNOOZE mode, press any other button – the icon will stop flashing and will remain on
the screen.
The alarm will be re-activated the next day.
If you do not press any button while the alarm is ringing, the ringing will stop automatically after
2 minutes.
Display Backlighting
Press the SNOOZE/LIGHT button to activate display backlighting for 5 seconds.
Indoor and Outdoor Temperature, °C/°F Temperature Unit Setting
Indoor temperature is displayed in field 5.
Outdoor temperature is displayed in field 4.
If the station or the sensor detects values outside the range, it will show (HH.H/LL.L).
If indoor temperature is between 15 and 25 °C and indoor humidity is above 65 %, the icon will be
displayed.
This icon means higher probability of mould forming in the room.
If outdoor temperature is higher than 35 °C, the icon will be displayed.
If outdoor temperature is below -3 °C, the
icons will be displayed simultaneously.
If outdoor temperature is between -3 °C and +1 °C, both icons will be flashing.
Long pressing the
button will switch temperature units between °C/°F.
Displaying Maximum and Minimum Readings of Temperature/Humidity/Pressure
Repeatedly pressing the
button will gradually show the maximum (
icon) and minimum (
icon) values of temperature/humidity/pressure measured in the last 24 hours.
The memory of measured values is automatically erased every day at 00:00.
Atmospheric Pressure/History
The station shows the atmospheric pressure value in hPa and keeps a history of pressure readings for
the last 12 hours in field no. 9.
