Emos E0305, Operating Instructions Manual

Page: 4 / 64

4
DOWN
Change
tem-
perature
units
°C/°F
Set
tempera-
ture alert
values
1 step
back
Faster
setting
1 step
back
Faster
setting
1 step
back
Faster
setting
MODE
Alarm
on/off
Time
settings
Confirm
settings
Confirm
settings
ALARM
Alarm
time
Alarm
settings
Confirm
settings
CHA-
NNEL
Sensor
channel
1–3
Search
for sen-
sor RF
signals –
pairing
LIGHT/
SNOOZE
Display backlight/
snooze
Display backlight
Specifications:
indoor temperature: -10 °C to +50 °C, increments of 0.1 °C
outdoor temperature: -50 °C to +70 °C, increments of 0.1 °C
temperature measurement accuracy: ±1.0 °C
indoor humidity: 18 % to 98 % RH (relative humidity), increments of 1 %
outdoor humidity: 20 % to 95 % RH (relative humidity), increments of 1 %
humidity measurement accuracy: ±5 %
radio signal range: up to 30 m in an open area
number of sensors which can be connected: max. 3
clock controlled by DCF radio signal
wireless sensor transmission frequency 433 MHz, max. 0.1 mW e.r.p.
Power Supply:
main unit: 2× 1.5 V AA batteries (not included)
sensor: 2× 1.5 V AAA batteries (not included)
Dimensions and Weight:
main unit: 28 × 114 × 180 mm; 211 g (without batteries)
sensor: 23 × 60 × 92 mm; 54 g (without batteries)
Operating Instructions
1. First, insert batteries into the weather station (2× 1.5 V AA), then into the wireless sensor (2× 1.5 V AAA). When
inserting the batteries make sure the polarity is correct to avoid damaging the weather station or sensor. Only
use alkaline batteries of the same type, do not use rechargeable batteries.
2. Place the two units next to each other. The weather station will automatically detect the sensor signal within
3 minutes. If the sensor signal is not detected, long press the CH button to repeat the search for remote sensor signal.
3. If the outdoor temperature value disappears from the display, repeat steps 1 and 2.
If you want to have multiple sensors connected, you must set a different communication channel number for
each using the CH button located in the sensor’s battery compartment.
4. We recommend placing the sensor on the north side of the house. The range of the sensor may decrease substan-
tially in areas with large number of obstacles. The sensor is resistant to dripping water; however, it should not be
exposed to sustained rain. Do not place the sensor on metal objects as this reduces transmission range.