3
5 – battery compartment
6 – stand
7 – sensor channel number 1/2/3 icon
8 – outdoor temperature
9 – LED of signal transmission from the sensor
Attention
Only use 1.5 V alkaline batteries of the same type; do not use recharge-
able 1.2 V batteries.
Lower voltage may cause the sensor and station to not function.
We recommend placing the sensor on the north side of the house.
The range of the sensor may decrease substantially in areas with large
number of obstacles. The sensor is resistant to dripping water; however,
it should not be exposed to sustained rain. Do not place the sensor on
metal objects as these would reduce transmission range.
The sensor can be placed vertically or hung on a wall.
Pairing the Sensor with the Weather Station
1. Long-press the
CHANNEL
button on the back of the weather
station; the icon will start flashing.
2. Remove the cover from the battery compartment and insert
batteries (2 x 1.5 V AAA).
3. Set the sensor channel number (1, 2, 3) of choice by sliding the
switch (icon no. 4) located in the battery compartment of the
sensor. The channel number will be shown on the sensor's display
on the right. Data from the sensor will be loaded into the station
within 3 minutes. Repeat the whole process or press the TX button
if sensor signal is not detected.
Safety Instructions and Warnings
Read the user manual before using the device
Follow the safety instructions stated in the manual
The product is designed to serve reliably for many years if used
properly.
• Read the manual carefully before using this product.
• Do not expose the product to direct sunlight, extreme cold and
humidity and sudden changes in temperature.
