emmeti 07917515, Installation And Use Manual, Page: 20 / 36

GB
20
Models: Dual / Trial / Quadrial
The indoor units must be put into service in the same
operational mode or in compatibility mode according
to the table below
√
= Normal X= Interference
The outdoor unit always operates in the mode of the
first indoor unitturned/on. If a subsequent indoor unit
is set in a way that interferes with the first one, the
unit that has caused the interference will be automa-
tically turned off.
1.3
Setting desidered temperature
Press
button to set desired temperature (with the
appliance switched off and without any preset timer).
flashes on LCD Display
Press , to increase temperature of 1 C°;
Press , to increase temperature of 1 C°;
Once the desired temperature is reached, it will flash
for 3 seconds before being confirmed.
The default temperature range is 18-32 ° C (in cooling,
heating and dehumidification mode).
In FAN ONLY mode it is not possible to set the
temperature. The default range can be changed by a
qualified installer
The indicatore ‘Temperature Range Limit’ flashes
when trying to set the temperature beyond the default
range (18-32 ° C).
1.4
Fan speed Setting
Press the FAN button to select the desired fan speed.
Each time the FAN button is pressed the speed chan-
ges in sequence:
In dehumidification mode the fan speed is automati-
cally set to AUTO, the FAN button is inactive.
1.5 Adjusting the air flow direction
(not valid for duct)
Press SWING button to select the air flow desired
direction. Each time the SWING button is pressed, the
direction changes in sequence (up / down (vertical);
right / left (horizontal); together vertical and horizontal):
available only for some models
1.1
On / Off
To turn on the air conditioner press the ON / OFF but-
ton, the ON light (blue) lights up, the appliance starts.
To turn it off, press the ON / OFF button again, the ON
light (blue) goes off, the appliance stops.
Hold down the "ON / OFF" button for more than 3
seconds, the appliance will go completely to a stop
state (the indoor unit stops, the ON timer cannot be
used to switch it on, only manual start), the buzzer
will emit 4 beeps
The infrared remote control can control the wire
control.
1.2
Setting the operating mode
Press the "MODE" button (with the appliance
switched off and without any preset timer), to select
the operating mode.
Each time the "MODE" button is pressed, the opera-
ting mode changes in sequence:
COOLING HEATING AUTO FAN ONLY DRY
Cooling Dry Heating Fan
Cooling
√ √
X
√
Dry
√ √
X
√
Heating X X
√
X
Fan √ √ X √
7