emmegi GIOCAMPER M7 T-Sat, Instructions For Use & Warranty

Page: 4 / 16

4
6. Untighten the 2 dish holder
screws and leave the dish to go
down, leaning on the abs white
carter as shown in the picture.
The LNB have to be in contact
with the dish. (do not put any
material between LNB and
dish)
7. Tighten the screws in order to avoid free movement of dish. Pay attention to not force too
much.

Fixing of plate:
WARNING: we suggest to place the antenna in the middle of the vehicle roof, or driver side. A lateral
positioning is more exposed to unintentional damage, like trees at side street.
NEVER PLACE IT ON THE INCLINATED AREA OF VEHICLE (BUNK).

Check the space available around the plate positioning point to avoid hitting obstacles during
rotation (oblo, cappe, ecc.):
-
For 60 model at least 30cm of free space around the plate positioning point.
-
For 70 model at least 35cm of free space around the plate positioning point.
-
For 80 model at least 40cm of free space around the plate positioning point.

Clean with a diluent the area of gluing on the fixing plate. We suggest you do not use
commercial grease/dirty remover because they leave a protective patina.
If necessary use a sandpaper fine-grained to remove smog.

Clean with a diluent the fixing plate and wait that is completely dry before applying the glue.

Distribute glue (POLIURETANIC) on the fixing plate, drawing tight rows to avoid emty space. We
suggest to perform even the contour of the fixing plate to avoid water infiltration.

Press the glued fixing plate on the roof, paying attention to remove bubbles of air and aligning
the fixing plate with vehicle side.

Take care of the fixing plate contour, sealing the four side will prevent water infiltration, very
dangerous during winter time (water icing could separate glue from roof).

Remove glue in excess.

Let dry the glue according times listed below:

At least 24h during hot days (For example during springs or summer).

At least 36/48h during cold days (For example during autumn or winter).

After drying time you can proceed with installation of the product.

Positioning of the antenna:

Remove from the plate the first 4 bolts (8mm).

Place antenna on the plate, paying attention to join each pins and holes.
WARNING: Antenna is sent out in TRAVEL POSITION, that is to say that LNB have to be backside
of camper. (Look the picture in the next page).

Tight the four 8 mm bolts using the correct size tool.