016
Operation
Operation
Turn ON Sequence (continued from previous page):
5. Turn ON (up position) Main Power Breaker Switch.
6. Check that the MTRX2 indicator lights are RED (Standby Mode)
7. Push the Standby button on the front panel
8. MTRX2 indicator lights will blink BLUE while going through safety startup sequence
then will glow solid BLUE once fully turned ON.
Turn OFF Sequence:
1. Push the Standby button on the front panel to put MTRX2 amplifier back into
Standby Mode. Indicator lights will go from BLUE to RED
2. Once in Standby Mode you can remove the audio source cables (XLR/RCA)
3. Turn OFF (down position) the Main Power Breaker Switch to completely turn off the
MTRX2 amplifier and to remove speakers cables or disconnect power cables.
MTRX2 Power Modes and Precautions:
MTRX2 amplifier should always be placed in Standby Mode before turning the Main Power
Breaker Switch OFF (down position). Turn the Main Power Breaker Switch OFF (down
position) before removing speaker cables, power cables or when moving or relocating the
MTRX2 amplifier.
We recommend unplugging the MTRX2 (30A 250V 3-pin, IP44, IEC60309 type) from the
main AC circuit during lightning storms or when unused for extended periods of time to
prevent damage from power surges.
Main Power
Breaker Switch
Power
Inlet
Voltage
Indicator Label
MTRX2 AMPLIFIER OWNER’S MANUAL
© 2017 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
